Nobody can quote lighting in Hollywood honestly from a web page, because the price of the same six recessed lights changes completely depending on what is above your ceiling and whether power already runs to the spot. What we can do is show you exactly what a real estimate is built from. Below are the 8 factors that decide what your lighting job costs, so you can look at any quote you receive and understand what you are actually paying for.
- Swapping a fixture where power already exists is the cheapest possible lighting work. Adding a light where none existed is the most expensive.
- Concrete slab ceilings, common in older Hollywood homes and condos, cost more to light than drywall with an attic above.
- Fixtures themselves are a separate line from labor, and the fixture you pick can move the total more than the install does.
- Lighting done during a kitchen or bathroom remodel is cheaper than lighting done on its own, because the ceilings and walls are already open.
- Call Green Contractors FL at (786) 519-0391 for a walkthrough and a written number for your rooms.
1. Whether you are replacing a fixture or creating a new one
This is the single biggest split in any lighting price. If a box, a wire and a switch already exist and you are changing what hangs off them, the work is short and the cost reflects that. Creating a light where none existed means running new cable, adding a box, patching and finishing, and that turns a one-hour job into a project with a drywall and paint tail behind it.
2. What your ceiling is made of
A lot of Hollywood housing stock is concrete. Second-floor slabs and condo ceilings do not have a cavity to hide a can light in, so the answer is usually surface-mounted fixtures, a dropped soffit or a furred-out section instead of standard recessed cans. A drywall ceiling with an accessible attic above it is the easy case. Anything else means the ceiling has to be built before the light can go in it, and that is construction, not a fixture swap.
3. Ceiling height and access
Ten and twelve foot ceilings, vaulted living rooms and stairwell lights need more than a step ladder, and the extra time shows in the estimate. Popcorn or knockdown texture adds another step, because any opening cut into it has to be patched and re-textured to match the rest of the room or the repair will be visible from the doorway forever.
4. How many fixtures, and how they are laid out
Cost per fixture drops as the count goes up, because the crew, the setup and the trips are already paid for on the first one. Six cans in one kitchen ceiling is a far better price per light than two cans in the kitchen and one in a hallway on the other side of the house. A proper layout also matters for the result, not just the price: evenly spaced lights on a dimmer beat a larger number of badly placed ones.
5. Who supplies the fixtures
Labor and materials are two different numbers. Homeowners regularly pick fixtures that cost more than the installation, especially with decorative pendants, chandeliers and designer trims. If you supply your own, we install what you bought. If you want us to supply them, we set an allowance with you first, so the fixture budget is a decision you make on purpose instead of a surprise at the end.
6. Switching, dimming and controls
Dimmers, three-way switching for a room with two entrances, separate zones for an island and a perimeter, and smart controls all add wiring and devices. This is the part people forget when comparing two quotes. A cheaper number sometimes just means everything lands on one switch, which is fine in a closet and frustrating in a living room.
7. Permits and inspection on work that requires them
Straightforward like-for-like replacement generally does not trigger a permit. New circuits, panel work and lighting that is part of a larger renovation usually do, and permitted work carries city fees plus the schedule of an inspection. We handle that process as part of the job. It is worth knowing which category your work falls into before you compare bids, because an unpermitted shortcut becomes your problem at resale, not the installer’s.
8. Whether the lighting is part of a bigger remodel
Lighting is dramatically cheaper while the walls and ceilings are already open. During a kitchen or bathroom remodel, under-cabinet lighting, recessed cans, vanity lighting and a new pendant over the island are incremental work on a site that already has a crew, a permit and exposed framing. Adding the same lights a year later means cutting into finished ceilings and repainting rooms you just paid to finish. If a kitchen remodel is part of your plan, How Much Does Kitchen Design Cost in Hollywood, FL? breaks down that budget as well.
What to Ask For So You Can Compare Quotes
When you get estimates in Hollywood, ask every contractor to break the number down the same way. Look for:
- Labor and materials separated, so you know what the fixtures are costing you
- Fixture count and location by room, not a single lump sum for “lighting”
- Switching and dimming spelled out, including how many zones
- Patch, texture and paint named clearly as included or excluded
- Permit responsibility, stated in writing
If two quotes are far apart, the gap is almost always hiding in those last three lines.
Get a Real Number for Your Home
There is no honest flat rate for lighting, but there is an honest quote for your specific rooms, and that takes a walkthrough. Green Contractors FL is a family-owned contractor based at 4624 Hollywood Blvd #203 in Hollywood, and we handle lighting on its own as well as within full kitchen and bathroom remodels across Broward, Miami-Dade and Palm Beach County. Financing is available if you would rather spread the project out.
Call (786) 519-0391 to schedule an estimate, and we will walk your ceilings, tell you which of the eight factors above apply to your home, and put a written price in front of you.
Frequently Asked Questions
Why will not a contractor just tell me the price per recessed light in Hollywood?
Because the same fixture can be a quick swap or a small construction project depending on your ceiling. A drywall ceiling with attic access above it and a concrete slab ceiling in a Hollywood condo produce completely different numbers for identical lights, and no accurate figure exists until someone has seen the ceiling.
Is it cheaper to add lighting during a kitchen or bathroom remodel?
Yes. While ceilings and walls are already open and a crew is already on site, lighting is incremental work. Doing the same recessed cans, under-cabinet strips or vanity lighting after the remodel is finished means cutting into new finishes and repainting, which adds cost that did not need to exist.
Do I need a permit to add lighting to my home in Hollywood?
It depends on the scope. Replacing an existing fixture in place generally does not, while new circuits, panel work and lighting that is part of a larger renovation usually do. We identify which applies during the estimate and handle the permitting on jobs that require it.
Should I buy my own light fixtures or have the contractor supply them?
Either works. Supplying your own gives you full control of the fixture budget and style, and we install what you purchased. If you prefer us to supply them, we agree on an allowance up front so the fixture cost is a decision you make before the job starts rather than a line you discover at the end.
Does Green Contractors FL offer financing on remodeling work?
Yes, financing is available. Terms and approval are handled through the lender, so the right next step is to call (786) 519-0391 and go over the project scope and the options with us.